tests/17-07-31_accusticarts
 
Test.
Deutsch English|

Accustic Arts Mono II

25.08.2017 // Dirk Sommer

But let’s now go back to the Mono II, the second-largest amplifier in the Swabian’s reference line, which I have chosen because its opulent output power range of 300 watts at eight and 500 watts at four ohms is being more than enough for my system’s requirements. However, in contrast to the 60 kilograms of the top model Mono III, the Mono II only weighs “amicable” 25 kilograms. The discussion with the designer revealed that the Mono II despite its XLR input is not a balanced amplifier in its own right. If one selects the balanced input, the audio signal is converted into an un-balanced signal using an IC from Burr Brown and then treated in the same way like the signal entering the power amp through the RCA input. One could now begin to hotly dispute whether it would be better to lead the signal through the RCA output of Einstein's fully balanced The Preamp, thereby bypassing AccusticArts’ un-balancing circuitry or benefiting from the less susceptible balanced signal routing on the six meters long cables between pre and power amplifiers. Since there were no un-balanced signal cables around that could match the quality of my XLR connections, I will excuse myself from further musings on the matter, leaving everything the way it was by simply replacing Einstein’s The Poweramp with the two Accustic Arts Mono II.

The Mono II are designed for bi-wiring. The mains phase has been marked
The Mono II are designed for bi-wiring. The mains phase has been marked

After having passed the RCA input respectively the un-balancing circuitry, the signal is fed into a Burr Brown class A current amplifier. As Accustic Arts’ electronics designer explains, this is an extremely linear class A current mirror driver stage using six characteristic curve selected high-frequency transistors, which at the same time defines the relatively high bias current and the DC zero point for the twelve MOSFET power transistors selected in the same way. The power amp produces an astonishingly small percentage of distortion. In addition, 99% of the distortion spectrum consists of K2, aka harmonic distortion, which the ear perceives as pleasant. For the protection circuit, he defined a specific frequency curve in order to make a DC avoiding servo circuit at the output obsolete. Capacitors in the signal path he omitted as well. The capacitors next to the signal path are FKPs or polypropylene foil capacitors from Wima with a maximum tolerance of one percent. Except for the source and Boucherot resistors, only metal film resistors with a tolerance of one percent are used. Regarding the Boucherot resistors only metal oxide layer types with low inductivity and also a maximum deviation from the nominal value of one percent are allowed. All source resistors come up as low-inductance metal-band versions with ceramic housings.

For the Mono II, Accustic Arts focusses on an un-balanced circuitry. Nevertheless, balanced signals are accepted as well
For the Mono II, Accustic Arts focusses on an un-balanced circuitry. Nevertheless, balanced signals are accepted as well

A considerable effort is also applied to the power supply. The 1,200 VA toroidal mains transformer is manufactured according to Accustic Arts’ specifications and shows an additional copper band winding for statical screening, a potted structure, a MU metal magnetic shielding, and has separate windings for the positive and negative supply voltages for the MOSFET output stage, as well as for the input and driver stages. Their share of the total capacity of more than 80,000 microfarads is multiplied by a newly developed capacitance multiplier circuit similar to a gyrator. Ultra-fast switching diodes are used for rectifying both voltages. Although the Mono IIs admittedly have a high damping factor, it isn’t the absolute value – this is varying between 400 and 1000, depending on the measurement method – that’s got the highest priority for their developer, but more the fact that the damping factor stays linear beyond the audible range. This makes the work for the connected loudspeakers a lot easier.


  • Accustic Arts Power I MK 4 und Player I

    Nach langer Testabstinenz, ausgelöst durch berufliche Veränderung und Umzug, hatte ich das Vergnügen, in den letzten Wochen die Kombination aus dem Vollverstärker Power I MK 4 und dem CD-Spieler Player I von Accustic Arts zu testen. Sie haben richtig gelesen, auch wenn ich damit vorgreife: Es war ein Vergnügen! Aber jetzt erst einmal zu den technischen Details. Bei beiden Geräten fällt gleich nach dem Auspacken auf, dass sie zum einen ordentliches Gewicht aufweisen und zum…
    19.01.2018
  • BlockAudio Line & Power Block and Mono Block

    BlockAudio was founded by two HiFi and music enthusiasts because amplifiers available on the market failed to meet their expectations in terms of sound, finishing or the price performance ratio. Their first pre/power amplifier combination has a price of 70,000 Euro. No, this doesn’t mean you can smirk, it is not a contradiction: Their amplifiers convince in all three criteria. Jiri Nemec and Dan Oudes have been working together since 2003; they were enthused by…
    02.09.2017
  • Accustic Arts Mono II

    Das schwäbische Traditionsunternehmen Accustic Arts feiert heuer seinen 20. Geburtstag. Während man sich im Fernen Osten schnell einen guten Ruf erwarb und auch kommerziell sehr erfolgreich war, blieb der Prophet im eigenen Land weniger präsent. An den Produkten liegt es gewiss nicht, wie die Mono II beweisen. Es war eher eine Entscheidung der früheren Firmenleitung, sich vorrangig auf den Export zu konzentrieren. Vor zwei Jahren erwarb dann Hans-Joachim Voss die Firma und kümmerte sich natürlich…
    31.07.2017
  • BlockAudio Line & Power Block und Mono Block

    BlockAudio wurde von zwei Hifi- und Musikenthusiasten gegründet, weil die verfügbaren Verstärker ihre Erwartungen in puncto Klang, Verarbeitung oder Preis/Leistungsverhältnis nicht entsprachen. Ihre erste Vor/End-Kombination kostet 70.000 Euro. Nein, das ist kein Grund zum Schmunzeln, kein Widerspruch: Ihre Verstärker überzeugen in allen drei Kriterien. Jiri Nemec und Dan Oudes arbeiten schon seit 2003 zusammen, sie haben sich für die Lautsprecher-Bausätze von Dynaudio begeistert und gemeinsam Boxen gebaut. Dan Oudes betreibt im Tschechischen Olomouc oder Olmütz…
    16.05.2017
  • Ayon Scorpio

    Das muss ein Ayon sein, den erkenne ich sogar aus der Ferne und ohne Brille! Was hier als schmales Hemd daherkommt – zumindest aus Ayon-Sicht - stellt das Einsteigermodell der Firma in die Welt der Röhren Monoblöcke dar. Ich muss zugeben, das Design gefällt mir, keine Rallye-Streifen, kein tiefer gelegter Auspuff, nichts aus der Glamourwelt. Die Gehäuse sind makellos solide gebaut und mit 15 kg pro Gerät noch gut transportabel. Sagt mein Kreuz. Insgesamt macht…
    23.01.2017
  • Musical Fidelity M8-700m

    Wer möchte nicht gerne der Nachfolger eines Titanen sein? Fußballweltmeister Manuel Neuer hat den Titan Oliver Kahn erfolgreich beerbt und Musical Fidelity Gründer Antony Michaelson preist die Monoblöcke M8 700m als preisgünstige und mindestens ebenbürtige Nachfolger zu den nicht mehr gebauten Limited-Edition-Referenzendstufen Titan. In die Fußstapfen eines 158 Kilogramm schweren Vorbildes zu treten ist beileibe kein einfaches Unterfangen – vor allem dann, wenn man selbst „nur“ 30 Kilogramm (pro Monoblock) in die Waagschale wirft. Vielleicht…
    26.06.2015

Wir nutzen Cookies auf unserer Website. Einige von ihnen sind essenziell für den Betrieb der Seite, während andere uns helfen, diese Website und die Nutzererfahrung zu verbessern (Tracking Cookies). Sie können selbst entscheiden, ob Sie die Cookies zulassen möchten. Bitte beachten Sie, dass bei einer Ablehnung womöglich nicht mehr alle Funktionalitäten der Seite zur Verfügung stehen.